Instructions for locking TSOP

To Lock the TSOP, Connect the 2 wires that are exiting the back of the chip with the jumper.   When switching from locked to unlocked, make sure you unplug your receiver

*If you get an error message saying "There is a Serious Problem Detected" click here.

Hint: If you are having trouble getting your soldering connections to stay, try applying super glue over the conectins after you have soldered them,  this usually will do the trick!


For x700, x800, x900 Receivers w/ R259:

Pin 1 (Orange) goes to WE TSOP Side (Left of R259)
Pin 5 (Brown) goes to WE Supply Side (Upper Left of SB16)
Pin 7 (White/Brown Stripe) is grounded (left of C196)
Pin 8 (White/Blue stripe) goes to DQ4 (SB42)
Pin 9 (Green) goes to DQ1 (Upper Left of SB22)
Pin 14 (Blue) goes to VCC (right of C196)

 

r259remove.jpg (32345 bytes)

To remove R259

3700-points.jpg (203150 bytes)

x700, x800, x900 Board w/R259

 

For x700, x800, x900 Receivers without R259:

Pin 1 (Orange) goes to WE TSOP Side (To Pin 18 of 244 in picture)
Pin 5 (Brown) goes to WE Supply Side (
To pin 2 of 244 in picture)
Pin 7 (White/Brown Stripe) is grounded (left of C196)
Pin 8 (White/Blue stripe) goes to DQ4 (SB42)
Pin 9 (Green) goes to DQ1 (Upper Left of SB22)
Pin 14 (Blue) goes to VCC (right of C196)

x700, x800, x900 Board W/out R259

 


For 301.013

Pin 1 (Orange) goes to WE# TSOP Side
Pin 5 (Brown) goes to WE# Supply Side
Pin 7 (White/Brown Stripe) goes to Ground
Pin 8 (White/Blue stripe) goes to DQ4
Pin 9 (Green) goes to DQ1
Pin 14 (Blue) goes to VCC +3.3 Volts

301.013.jpg (138207 bytes)


Click here to download 301.010 instructions

Pin 1 (Orange) goes to WE# TSOP Side at R259
Pin 5 (Brown) goes to WE# Supply Side at SB16
Pin 7 (White/Brown Stripe) goes to Ground at R254
Pin 8 (White/Blue stripe) goes to DQ4 at R281
Pin 9 (Green) goes to DQ1 at R263
Pin 14 (Blue) goes to VCC +3.3 Volts at R282


Click Here for Eeprom Lock Instructions